I have been trying to join a Cisco NSS2000 device to a Windows Server 2008 based active directory and each time that I try to join I see a window with the error "error joining to ADS domain" and "Join to domain is not valid". I know the credentials I am using are valid and have domain admin rights. The appliance is also using the DC as an NTP source and I have confirmed the clocks are synced.
Looking in the CIFS logs I can see the following entries.
Feb 8 14:06:38 NAS01 winbindd: Could not fetch sid for our domain MYDOMAIN
Feb 8 14:10:07 NAS01 winbindd: [2010/02/08 14:10:07, 1] nsswitch/winbindd_ads.c:ads_cached_connection(81)
Feb 8 14:10:07 NAS01 winbindd: ads_connect for domain MYDOMAIN failed: Cannot read password
Feb 8 14:15:08 NAS01 winbindd: [2010/02/08 14:15:08, 1] nsswitch/winbindd_ads.c:ads_cached_connection(81)
Feb 8 14:15:08 NAS01 winbindd: ads_connect for domain MYDOMAIN failed: Cannot read password
Does anyone have any ideas on how I can successfully join this box to my domain?
I think I may have answered my own question - I am currently running v1.13 of the firmware and the release notes for this indicate it is not compatible. v1.16 being downloaded now which will hopefuly the resolve the issue.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...