Please reference page 17 of the NSS3XX Admin Guide. The solid RED HD LED indicates there is a read/write error on that particular HD. This may indicate a hard drive failure. You could remove that HD and place back into the NSS into another HD bay and run the setup again to see if the problems remains with that hard drive or not. If you purchased this HD with the NSS you would need to contact the Small Business Support Center for assistance in getting this hard drive replaced. If you purchased the chassis with no hard drives then you would need to contact your hard drive reseller for replacement assistance.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...