There is another post here asking the same basic question; how can you monitor (Install SNMP Agent) on the NSS?
Unfortunately, we can't; at least I have not been able to find a way to do this. The main reason is part of your question; "How can you set the community?", there is no way to do that. All we can do is set the traps, and let our SNMP software catch them. As for looking directly at the CPU load, memory, etc. we..err; should say, I have not been able to do this in my lab. Packet captures do show the information flowing, and traps do work; the bummer part is that we really can't be very pro-active.
I hope someone else sees this post and correct what I am saying.
Article ID:1717 Time Machine Backup on NSS300 Smart Storage Series
Objective This document explains the steps for Time Machine Backup. The
Network Attached Storage (NAS) is used as one of the destinations for
the backup of files. It is a file-level comput...
Article ID:28 Basic and Advanced System Reset on NSS300 Series Smart
Storage Objective The NSS devices have two types of System Resets: Basic
and Advanced. An understanding of both of these resets will allow the
user to recover from unpredictable situatio...
Article ID:40 Expansion of Disk Capacity of RAID 5 on the NSS300 Series
(Except NSS322) Objective RAID stands for Redundant Array of Independent
Disks. RAID 5 combines three or more disks in a way that shields the
data against loss of any one disk. In a R...