What UPS do you recommend for the NSS3000?? keeping in mind that I want the UPS to send a signal to the NSS (when there is not power), and start the automatic turn off.
Im sorry with this, but I just want to be sure and make the correct buy....
Summary: APC is actually a CHOICE of UPS for the NSS3000, or the Storage System MUST have an APC UPS brand?. It would be very cool if by any chance you could see the link of the Trip-Lite UPS that I attached, because I'm not sure if that Trip-Lite UPS is compatible with the NSS3000... or should I better start to looking for an APC UPS?...
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...