-I don't understand well the radius server in this product. Does it works like a Radius server totally independent of NSS or the users you create in Radius Server are using later to give permissions over folders (I don't understand how). My question is: could you use NSS 300 series like an ACS with less funcionality?
-and the other question is about CIFS and NFS, could you use the same volume with CIFS and NFS?
The NSS3XX series are capable of running a standard RADIUS server, not specific to users of the storage component. This is an "extra" application that the platform can perform in addition to being a storage server. Secondly you can have CIFS and/or NFS users access the same volumes.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...