Have implementation of 2 2851 Routers connected via 10mb EPL connection interlinking two sites via 10mb Etherenet Private Line (via int g0/1), need to know if possible to insert new HWIC T-1/ISDN PRI to supply connectivity between both ends. Traditional ROLM Phone system on T-1/PRI port to 2nd site at other end of 10mbEPL to a Media GW that will convert to access for a VoIP PBX. Concern is of course that this traffic be given priority over the 10mb EPL over any data that would be input and carried and normal data connectvity is via G0/0. Have diagram as attachment is pdf. If any one has done this would it be possible to share a config.
Thanks for your post! Since this is not a small business product, I suggest posting your question to the Networking Professoinal Connections (NetPro) Discussion Forum for input from appropriate subject matter experts. NetPro is a peer and expert forum where you can get suggestions and information from networking professionals on a variety of solutions and technologies. The NetPro forums have many threads on the 2851 and I'm sure someone over there will be able to help you.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...