Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ADSL Connection issues

Hello all,

I am having issues with two seperate sites. I will post the output below, I am confused though to the bad service we are receiving as the output seems to be fine according to all that I have read. Any second opinions would be brilliant.

Site A.

Modem Status:    Showtime (DMTDSL_SHOWTIME)

DSL Mode:        ITU G.992.1 (G.DMT) Annex A

ITU STD NUM:     0x03                            0x3

Vendor ID:       'STMI'                          'TSTC'

Vendor Specific: 0x0000                          0x0510

Vendor Country:  0x0F                            0xB5

Chip ID:         C196 (0)

DFE BOM:         DFE3.0 Annex A (1)

Capacity Used:   100%                            53%

Noise Margin:    14.5 dB                         22.0 dB

Output Power:    20.0 dBm                        12.5 dBm

Attenuation:     39.5 dB                         22.5 dB

FEC ES Errors:    0                               0

ES Errors:       95                              13

SES Errors:       0                               0

LOSES Errors:     0                               0

UES Errors:       0                               0

Defect Status:   None                            None

Last Fail Code:  None

Watchdog Counter: 0xEB

Watchdog Resets: 0

Selftest Result: 0x00

Subfunction:     0x00

Interrupts:      12480 (0 spurious)

PHY Access Err:  0

Activations:     11

LED Status:      ON

LED On Time:     100

LED Off Time:    100

Init FW:         init_AMR_4.0.018.bin

Operation FW:    AMR-E-4.0.018.bin

FW Source:       external

FW Version:      4.0.18

                 Interleave             Fast    Interleave              Fast

Speed (kbps):          6240                0           448                 0

Cells:                61482                0        233742                 0

Reed-Solomon EC:          0                0             0                 0

CRC Errors:               0                0             0                 0

Header Errors:            0                0             0                 0

Total BER:                0E-0           0E-0

Leakage Average BER:      0E-0           0E-0

                        ATU-R (DS)      ATU-C (US)

Bitswap:               enabled            enabled

Bitswap success:          0                   0

Bitswap failure:          0                   0

Site B

                ATU-R (DS)                      ATU-C (US)

Modem Status:    Showtime (DMTDSL_SHOWTIME)

DSL Mode:        ITU G.992.5 (ADSL2+) Annex A

ITU STD NUM:     0x03                            0x2

Chip Vendor ID:  'STMI'                          'IFTN'

Chip Vendor Specific:  0x0000                    0x71C8

Chip Vendor Country:   0x0F                      0xB5

Modem Vendor ID: 'CSCO'                          '    '

Modem Vendor Specific: 0x0000                    0x0000

Modem Vendor Country:  0xB5                      0x00

Serial Number Near:    FCZ10421129

Serial Number Far:

Modem VerChip ID:        C196 (0)

DFE BOM:         DFE3.0 Annex A (1)

Capacity Used:   95%                             100%

Noise Margin:     8.0 dB                          6.0 dB

Output Power:    20.0 dBm                        12.5 dBm

Attenuation:     39.0 dB                         20.0 dB

FEC ES Errors:    1                               0

ES Errors:        1                               0

SES Errors:       1                               0

LOSES Errors:     1                               1

UES Errors:       0                              89

Defect Status:   None                            None

Last Fail Code:  None

Watchdog Counter: 0x95

Watchdog Resets: 0

Selftest Result: 0x00

Subfunction:     0x00

Interrupts:      8299 (0 spurious)

PHY Access Err:  0

Activations:     1

LED Status:      ON

LED On Time:     100

LED Off Time:    100

Init FW:         init_AMR_4.0.018.bin

Operation FW:    AMR-E-4.0.018.bin

FW Source:       external

FW Version:      4.0.18

                 DS Channel1      DS Channel0   US Channel1       US Channel0

Speed (kbps):             0             9014             0              1157

Cells:                    0           126169             0          37327987

Reed-Solomon EC:          0              600             0               259

CRC Errors:               0               16             0                32

Header Errors:            0               14             0                10

Total BER:                0E-0           1564E-10

Leakage Average BER:      0E-0           1750E-10

Interleave Delay:         0               52             0                11

                        ATU-R (DS)      ATU-C (US)

Bitswap:               enabled            enabled

Bitswap success:          0                   0

Bitswap failure:          0                   0

Thanks

Dan

Everyone's tags (1)
1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: ADSL Connection issues

I've deleted my post because someone's has given it a low score.  My findings are correct and true but the low score will be mis-interpreted by other people as an incorrect answer.  This I will not accept.

10 REPLIES
Hall of Fame Super Gold

ADSL Connection issues

Site "B" noise is not good. 

Refer to this document:  http://www.dslreports.com/faq/16220

New Member

ADSL Connection issues

Thanks for the reply Leo.

I have read the different docs, we are already using the noise-margin 3 command otherwise we would be in even more trouble.

The site is complaining that connections are really really slow. They are only using Citrix and the bandwidth looks fine, would the actual noise cause these issues?

D

Hall of Fame Super Gold

Re: ADSL Connection issues

I've deleted my post because someone's has given it a low score.  My findings are correct and true but the low score will be mis-interpreted by other people as an incorrect answer.  This I will not accept.

New Member

Re: ADSL Connection issues

Thanks for your input Leo its much appreciated.

I hear what you are saying, but I am still perplexed.

What I do not understand is why we get massive spikes in the ping when everything looks ok?

Noise Margin:    14.5 dB                         22.0 dB

Output Power:    20.0 dBm                        12.5 dBm

Attenuation:     39.5 dB                         22.5 dB

FEC ES Errors:    0                               0

ES Errors:        0                               0

SES Errors:       0                               0

LOSES Errors:     0                               0

UES Errors:       0                               0

Defect Status:   None                            None

Last Fail Code:  None

Watchdog Counter: 0xD8

Watchdog Resets: 0

Selftest Result: 0x00

Subfunction:     0x00

Interrupts:      4144 (0 spurious)

PHY Access Err:  0

Activations:     1

LED Status:      ON

LED On Time:     100

LED Off Time:    100

Init FW:         init_AMR_4.0.018.bin

Operation FW:    AMR-E-4.0.018.bin

FW Source:       external

FW Version:      4.0.18

                 Interleave             Fast    Interleave              Fast

Speed (kbps):          6976                0           448                 0

Cells:               103799                0        484147                 0

Reed-Solomon EC:         41                0             0                 0

CRC Errors:               0                0             0                 0

Header Errors:            0                0             0                 0

Total BER:                0E-0           0E-0

Leakage Average BER:      0E-0           0E-0

                        ATU-R (DS)      ATU-C (US)

Bitswap:               enabled            enabled

Bitswap success:          0                   0

Bitswap failure:          0                   0

Gold

Re: ADSL Connection issues

Dan,

Have you performed an MTU test?

- Marty

New Member

Re: ADSL Connection issues

MTU Test?

New Member

Re: ADSL Connection issues

with only half a meg upload and four + people using the site im wondering if it is more just a over saturation issue really..

Gold

Re: ADSL Connection issues

Dan,

I agree. Test it with only one PC working and see if you get good results. If yes, try using all four PCs simultaneously and see if you get ping spikes, slow speed, etc. Depending on what the users are doing, half a meg is pretty low for 4 users.

- Marty

Bronze

Re: ADSL Connection issues

I think you're just maxing out the bandwidth, which will result in all sorts of weird things since nothing is made for delays anymore.

If you can limit each computer to 10k/sec, see if that solves the error problem.  If so, then it's just being overloaded.

Huntsville's Premiere Car and Bike e-magazine: www.huntsvillecarscene.com

Huntsville's Premiere Car and Bike e-magazine: www.huntsvillecarscene.com
New Member

Re: ADSL Connection issues

I just wanted to say a huge thank you to everyone for all your advice and help.

Dan

415
Views
12
Helpful
10
Replies
CreatePlease login to create content