Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Build site to site VPN with Dynamic Rv120 to Asa5525-x with static

I need to use asdm to configure the asa5525 to accept remote site with dynamic public IP. Any suggestions or links to the process?
1 REPLY
New Member

Here is a sample

Below is the sample configuration between static and dynamic VPN peer address:

http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a00805733df.shtml

 

For dynamic to static VPN tunnel, the dynamic peer side will always have to initiate the vpn as the dynamic side knows about the peer ip of static asa, the static ip asa side cannot initiate the tunnel as the as doesn't know the destination peer ip as it is dynamic.

 

once the vpn is initiated and is up, both sides can talk to each other respectively.

88
Views
0
Helpful
1
Replies