I bought a RVS4000. If I follow the install directions, I am able to get internet access on my desktop. I can not, however, access the RVS4000. If I type in the address, I get the logon screen asking for the username and password. I use the default (admin for both) but it just goes back to asking for the username/password. I reset it to factory default settings but still this happens. I have used both xp and vista and both internet explorer and firefox. I get the some results with all of them. Does anyone know what I can do so that I can access the router?
I am sure I am leaving some important information out. If there is anything else that is needed, please let me know.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
** Update **These and a number of other issues have been addressed in
SRP520 MR3. Please see https://supportforums.cisco.com/docs/DOC-13853
for details on how to access this code.There have been a number of
reports of the SRP500 becoming unresponsive afte...
STANDARDSOURCECOMMENTSEthernet RJ-45 connector pin number12345678IEEE
802.3afusing data pairsRXDC+RXDC+TXDC-sparespareTXDC-sparespareIndustry
Standard for Embedded POE(used by Cisco Catalyst Switches)IEEE
802.3afusing spare pairs RXRXTXDC+DC+TXDC-DC-Indus...