Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Can the RV180W have multiple SSIDs with different security configurations?

I am trying to configure the RV180W with a guest network and regular wireless network. The regular wireless network is just a bridge to the wired network, using WPA2-Pers for authentication. I built and enabled another wireless SSID, using a different VLAN and no authentication. I can get both SSIDs to function at the same time if I turn off security. Once I turn on Security, the regular one no longer functions.

  • Small Business Routers
Everyone's tags (1)
5 REPLIES
Silver

Based on its documentation:

Based on its documentation: LINK HERE
It can support up to 4 SSIDs



Don't forget to rate and mark as correct! :)

New Member

I agree that it should

I agree that it should support it, but it doesn't seem to work. I haven't been able to find any documentation that shows how to set up multiple SSIDs.

Silver

It is actually all in the

It is actually all in the manual:

SEE: PDF MANUAL
Page 63 of PDF and onwards

Do note that you need to assign multiple VLAN per SSID. Check the manual it is there :D

and based on the manual you need to enable multiple VLAN support: See page 34 of the manual: Configuring Virtual LAN (VLAN) Membership

 

 

Don't forget to rate and mark as answer helpful posts! :)

New Member

I have VLAN 1 for the wired

I have VLAN 1 for the wired and regular network, and VLAN 10 for the Guest wireless. If I turn off Wireless Security both SSID's function. If I turn on WPA2 or WPA on one of the SSID's, the client cannot connect with that SSID. If I turn on WPA2 or WPA on both SSID's, client cannot connect to either SSID.

 

I will double check the VLAN configuration, but if I turn off security everything works.

Silver

Considering you constantly

Considering you constantly change the SSID setting auth/encry type. Did you make sure to delete the Wireless profile in your computer?

Computers remember the SSID they have connected to. If you don't delete/change their setting they can't connect.

49
Views
0
Helpful
5
Replies
This widget could not be displayed.