I have a UC540 that is set up to get a DHCP IP address from a public netblock on my network.
We also have a SR520 that is going to be deployed at a remote office once I get it fully configured.
The UC540 is set up as a EZVPN server
The SR520 is set up as a EZVPN client.
Everything works great with both units firewalls disabled.
When I use CCA to turn on the firewall to any setting (low, med, high), correctly setting up the inside and outside interfaces, wierd things start to happen.
All comms accross the tunnel work as normal.
The problem is that certain web sites won't load.
Yahoo loads great, google won't load for example.
The problem seems to be sites that possible have a redirect involved in loading the site, but thats just a guess.
Anybody else seen this problem?
It's frusterating because I'm trying really hard to use CCA for all the configuration. I could build a ACL based firewall easy enough using the CLI, but its my understanding that we're spupoused to use CCA.
Hello, This article will describe how to configure PPTP VPN on the new
RV340/345 routers from the Small Business series. RV340/345
Configuration The first step is to enable the PPTP Server: Go to VPN ->
PPTP Server Change PPTP Server: from Off to On Selec...
Article ID:5748 Use TheGreenBow VPN Client to Connect with RV34x Series
Router Introduction A Virtual Private Network (VPN) connection allows
users to access, send, and receive data to and from a private network by
means of going through a public or share...
Article ID:5728 Configure a Teleworker VPN Client on the RV34x Series
Router Objective The Teleworker VPN Client feature minimizes the
configuration requirements at remote locations by allowing the device to
work as a Cisco VPN hardware client. When the T...