I'm looking for someone who is familiar with the Cisco Enhanced Device Interface. I currently have the Cisco EDI running on a workstation that is connected to a Cisco switch. The switch is connected to the workstation, a Cisco Router, and some non-Cisco devices. I am trying to use the discover capabilities on the EDI, but am having no luck discovering the devices. Can anyone offer me some insight on possible preconfiguration that is necessary before you can discover devices or proper insight on how to use the discover commands?
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...