Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Cisco ISA550 routing public IP addresses

Hello,

 

I was assigned one public IP address for my WAN interface on my Cisco ISA550, but recently my ISP provided me with additional set of routed public IP addresses. I have a problem configuring ISA550 to route in/out new public IP addresses. I have created separate VLAN for routed set but it looks like a routing problem on ISA550 not allowing communication to public IP addresses from outside. Any advice?

 

Thank you. 

1 REPLY
Gold

Ordinaryman72, You will need

Ordinaryman72,

 

You will need to configure Static NAT under Firewall-> NAT before the additional public IPs will work.

 

- Marty

69
Views
0
Helpful
1
Replies
CreatePlease to create content