Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco RV042 Dual WAN VPN Router

We just bought the RV042 and need to understand how to config the below

I have 2 Internet Connection and connected to 2 WAN Ports and now I want few computers to get the Internet connection from WAN 1 and Few Computers from WAN 2.. How do I setup this? I have enabled DHCP so the router now gives the IP to computers

3 REPLIES
New Member

Need to check if the Source

Need to check if the Source Based Routing or Policy Based Routing can be configured.

 

Share the IOS version you are using ..

 

--

Parvesh

New Member

Hello Parvesh, I am using

Hello Parvesh,
 
I am using Cisco Small Business RV042 10/100 4-Port VPN Router and Firmware Version: v4.2.3.03 and I do have the following under Setup > Advance Routing and it has the below details
 
Destination IP :
Subnet Mask :
Default Gateway :
Hop Count (Metric, max. is 15) :
Interface : Options are LAN, WAN1 and WAN2
 
I tried the below settings to that 192.168.1.1.103 is going to Internet line 2 which is WAN2
 
Destination IP : 192.168.1.103
Subnet Mask : 255.255.255.0
Default Gateway : 192.168.1.1
Hop Count (Metric, max. is 15) : 1
Interface : Selected WAN2
 
Also I click on save the routing tables changed the value to 192.168.1.0
 
Thanks
Satish Kumar
 
New Member

Any idea's ?

Any idea's ?

373
Views
0
Helpful
3
Replies