Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Cisco RV042 protocol binding

Hi everyone, I looked for the answer to this on here and couldn't find it or maybe I missed it.  I am looking to bind all outbound traffic to one wan and all inbound to another.  I would also like it to failover in the event one of the wans go down.  Is this possible and if so how would I go about it?  Thanks in advance.

1 REPLY
Bronze

Cisco RV042 protocol binding

You can bind inbound/outbound traffic by protocol, but not inbound or outbound separately from what I remember.

If you did separate your traffic on different wans, you have to be in load balancing mode.  Failover mode only uses one wan at a time.  Hope this helps!

Huntsville's Premiere Car and Bike e-magazine: www.huntsvillecarscene.com

Huntsville's Premiere Car and Bike e-magazine: www.huntsvillecarscene.com
327
Views
0
Helpful
1
Replies
CreatePlease to create content