Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Cisco RV042

I installed a Cisco RV042 to a Cable connection and DSL line..

When I set the DSL line as primary and Cables and secondary and unplug  the DSL line to check if it switched everything works fine and the  computers switch to cable like nothing happened.

BUT

When I set cable and Primary and DSL as secondary and I unplug the cable line, it does not switch.. nothing happens.

and worse (not all) but some of the computers will not connect back to  the internet again when I plug the line back in nothing works I have to  reboot the switch router and computers to get anything back online..

FYI I disconnected the line running into the providers routers.

Any Ideas?

398
Views
0
Helpful
0
Replies
CreatePlease to create content