I just recently purchased a new NAS with two LAN Ports built into it. I plugged into both ports from two ports on my RV082 router (Ports 1&5). I was able to successfully bound those ports together on the NAS device. However my bandwidth didnt seem to improve. I was told by netgear support I needed to enable LACP on my router. I did not see how to do that or anything similar. The best i could find was setting High Priority tow LAN ports 1 and 5....any assistance would be helpful or any type of solution which will allow me to increase the bandwidth through those ports
Article ID:5748 Use TheGreenBow VPN Client to Connect with RV34x Series
Router Introduction A Virtual Private Network (VPN) connection allows
users to access, send, and receive data to and from a private network by
means of going through a public or share...
Article ID:5728 Configure a Teleworker VPN Client on the RV34x Series
Router Objective The Teleworker VPN Client feature minimizes the
configuration requirements at remote locations by allowing the device to
work as a Cisco VPN hardware client. When the T...
Article ID:5708 Configure the LAN and DHCP Settings on the RV34x Series
Router Objective A Local Area Network (LAN) is a network limited to an
area such as a home or small business that is used to interconnect
devices. LAN settings can be configured to li...