I have a problem with my cisco RV082 router to configure it to send SNMP traps to a SNMP server locally but do not see any traffic reaching the server snmp, set up a sniffer and monitoring traffic on the server and nothing, any suggestions?
Configuration of the router:
LAN IP 192.168.9.3/24
Get snmp comunity name: ciscorouter
Set snmp comunity name: ciscorouter
Trap comunity name: ciscorouter
send snmp trap to: 192.168.9.129
188.8.131.52.tm router firmware
I can connect to the router with snmp as well from the router I can ping to snmp server (192.168.9.129) the problem only arises because the router does not send any trap to the server.
Article ID:5748 Use TheGreenBow VPN Client to Connect with RV34x Series
Router Introduction A Virtual Private Network (VPN) connection allows
users to access, send, and receive data to and from a private network by
means of going through a public or share...
Article ID:5728 Configure a Teleworker VPN Client on the RV34x Series
Router Objective The Teleworker VPN Client feature minimizes the
configuration requirements at remote locations by allowing the device to
work as a Cisco VPN hardware client. When the T...
Article ID:5708 Configure the LAN and DHCP Settings on the RV34x Series
Router Objective A Local Area Network (LAN) is a network limited to an
area such as a home or small business that is used to interconnect
devices. LAN settings can be configured to li...