I have setup a 2 vlans on the RV120w I have inter-vlan routing unticked because each of the vlans is a separate client and I dont want them to be able to see each others PC's across the LAN. Except for one PC. Is there a way to setup a route for 1 pc to be able to have acces to another across the VLAN.
so PC at 192.168.3.195 needs to be able to see 192.168.4.90. port 32976
This has come about because the RV120 does not allow Hair Pinning. and we run a Neo Router server on the .4 range.
Hi Darryn, thank you for using our forum, my name is Luis I am part of the Small business Support community. You could select Deny and save the changes in order to set a default rule denying all access between Vlans, then create an access rule allowing port 32976 from the PC1 IP address to have access to both Vlan. That rules is going to give you access to the entire host in the Vlans. Please check the link below to see some steps.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...