I have made upgrade at my Cisco Router to Current Firmware Version 22.214.171.124 and I can not interconnect IP address with the MAC address now. It used to be there: LAN - IPv4 - Configure Static DHCP. But unfortunately a button "add" is missing now. Question: how will be possible to interconnect IP address with MAC address to be able to set a fixed IP address to the PC to MAC address?
Did you rebuild your config from scratch or somehow saved/restored it? If you saved/restored it, that may be the issue. This never works right with almost any brand of smb router. Reset the router to default config and reconfigure from scratch. I bet that will solve it.
Huntsville's Premiere Car and Bike e-magazine: www.huntsvillecarscene.com
Hello, This article will describe how to configure PPTP VPN on the new
RV340/345 routers from the Small Business series. RV340/345
Configuration The first step is to enable the PPTP Server: Go to VPN ->
PPTP Server Change PPTP Server: from Off to On Selec...
Article ID:5748 Use TheGreenBow VPN Client to Connect with RV34x Series
Router Introduction A Virtual Private Network (VPN) connection allows
users to access, send, and receive data to and from a private network by
means of going through a public or share...
Article ID:5728 Configure a Teleworker VPN Client on the RV34x Series
Router Objective The Teleworker VPN Client feature minimizes the
configuration requirements at remote locations by allowing the device to
work as a Cisco VPN hardware client. When the T...