cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
877
Views
0
Helpful
1
Replies

Cisco RV180 VPN Router

sokrates19
Level 1
Level 1

Hi,

I have made upgrade at my Cisco Router to Current Firmware Version 1.0.4.14 and I can not interconnect IP address with the MAC address now. It used to be there: LAN - IPv4 - Configure Static DHCP. But unfortunately a button "add" is missing now.
Question: how will be possible to interconnect IP address with MAC address to be able to set a fixed IP address to the PC to MAC address?

 

Thanks

1 Reply 1

SamirD
Level 5
Level 5

Did you rebuild your config from scratch or somehow saved/restored it?  If you saved/restored it, that may be the issue.  This never works right with almost any brand of smb router.  Reset the router to default config and reconfigure from scratch.  I bet that will solve it.
 

Huntsville's Premiere Car and Bike e-magazine: www.huntsvillecarscene.com
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: