Cisco RV220W - Turns on Isolation without being wanted?
A customer has a Cisco RV220W installed. It works properly for a period and then the device decides not to forward packets to devices on the wireless network that originate on the internal network. Connectivity to the WAN is not lost, but internal machines cannot connect to the wireless printers and internal machines cannot access a Windows share on another machine on the wireless network. When the problem occurs, Windows machine log browser errors and there are lots of elections for a browse master. Pings fail between wireless devices that had worked earlier.
I have upgraded the router to firmware Version 188.8.131.52, it was 184.108.40.206 and the problem has happened again. The configuration of the device is pretty vanilla except that it is forwarding the SFTP port to an internal machine. A single SFTP file transfer happens each night to one of the machines on the wireless network. I don't know if the SFTP fails when the above error occurs.
The first reported failure was on August 8 2014 and the second on October 1 2014. The failures aren't often enough to be able to test, but they are too often to be acceptable. The customer has agreed that we will replace this unit, most likely with a non-Cisco product, if the failure happens again and we don't have a way to possibly fix the issue from Cisco. This device does have an Isolation option that would result in the symptoms we see, but the Isolation option has never been selected and if it was, a power cycle on the device wouldn't clear the problem.
Any ideas as to what we can do to fix the problem?
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...