I have purchased the product in the subject as I needed 2 WAN for the load balancing of 2 ADSL (at the moment only one active), before I used a NETGEAR with DD-WRT firmware.
Having gone through the wizard router set-up, I noticed random timeout issues popping up where even the router adminweb doesn't load (set on 192.168.2.1 without the various VPN as they wouldn't have allowed the set up of such IP.) With the NetGear I have never experienced such problems..
Do you have an idea of what it might be? Because it's practically useless in its current state.
Can you confirm you've turned off "Enable Mirror Port (Port 1)" (under "Port Management"->"Port Setup") or can confirm the same happens when you do not have anything plugged into Port 1 (i.e. try Port 2)?
Please call in to the Small Business Support Center so we can look at your set up. We will be happy to make recommendations and provide a resolution. Please have your serial number handy and call us at 866-606-1866 during your normal business hours.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
** Update **These and a number of other issues have been addressed in
SRP520 MR3. Please see https://supportforums.cisco.com/docs/DOC-13853
for details on how to access this code.There have been a number of
reports of the SRP500 becoming unresponsive afte...
STANDARDSOURCECOMMENTSEthernet RJ-45 connector pin number12345678IEEE
802.3afusing data pairsRXDC+RXDC+TXDC-sparespareTXDC-sparespareIndustry
Standard for Embedded POE(used by Cisco Catalyst Switches)IEEE
802.3afusing spare pairs RXRXTXDC+DC+TXDC-DC-Indus...