Cisco SB RV110W has Dual Access(Russian PPPOE) or not?
Not sure that I understand the question.
But this router has only Single WAN interface. If you want a dual WAN then RV016, RV042, VR082 or SA500 should work for you. Those models support dual WAN capabilities.
Russian PPPoE or any other country should not be matter as long as the model of the device is supported by country. By model I mean SKU. Basically, if you got it in Russia, that that device should work just fine and it seems it is.
Now, if you connecting this router to your ISP (Internet Service Provider) modem then this router should be in the gateway mode. Router will separate WAN domain (Public IP) from LAN (private IP)
If you want Public IP(s) for your LAN devices, you can get a switch and put between ISP modem and router. But be sure to get a Public Static IPs from your ISP. This way your router will use one public IP and devices that connected to the switch can also have static IP(s)
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...