cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1431
Views
0
Helpful
1
Replies

Cisco WRVS4400N V2 - DIAG always on / no access

divandete
Level 1
Level 1

after a few months of trouble-free ... the Cisco WRVS4400N V2 stopped working.

i have tried to reset by holding the reset button for 30 seconds ... but nothing changes

the red DIAG light remains on at all times

i have also tried two different versions of the Firmware Rescue Utility but all i get is "unable to scan"

please help !

1 Reply 1

davidagu
Level 1
Level 1

Hello Vladimir,

Sorry you are experiencing this issue. It looks like your device is faulty.

Please give us a call at our support center so that we can check you warranty and setup up a possible replacment order. You can find a local number by going here: http://www.cisco.com/en/US/support/tsd_cisco_small_business_support_center_contacts.html

Thank you.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: