Cisco Support Community
Community Member

Configuring Linksys RVS4000 For Client VPN Using Quick VPN

As usual, the Cisco documentation on configuring this is sketchy. The QuickVPN document I have says you typically just need to create a user account on the router and install the client software.

So I created a user account on the RVS4000 and installed QuickVPN software version on my Windows 7 machine. Windows Firewall is running per instructions.

That's all I did.

When I fire up the client, enter my credentials and the IP of the RVS4000, it hangs on VERIFYING NETWORK and never progresses.

If I need additional configuration on the RVS4000 please provide step-by-step instructions. The manual I have for the RVS4000 seems to step through a site-to-site VPN configuration and not CLIENT VPN.

CreatePlease to create content