Does anyone know of a way to convert the RV220W small business router configuration to an RV320 small business router so I can inport the already built settings? I am in the process of replacing my RV220w with a RV320 router and didn't want to manually configure each piece. We have VPN setups, user setups, etc..
Or is there a step by step manual I can follow to perform this process?
It is not possible to convert the RV220W config to an RV320 config. The easiest way to copy the settings manually is to connect to both routers at the same time and copy the settings page by page. Change the LAN IP to match as the final step after disconnecting the RV220W to avoid IP conflict.
Hello, This article will describe how to configure PPTP VPN on the new
RV340/345 routers from the Small Business series. RV340/345
Configuration The first step is to enable the PPTP Server: Go to VPN ->
PPTP Server Change PPTP Server: from Off to On Selec...
Article ID:5748 Use TheGreenBow VPN Client to Connect with RV34x Series
Router Introduction A Virtual Private Network (VPN) connection allows
users to access, send, and receive data to and from a private network by
means of going through a public or share...
Article ID:5728 Configure a Teleworker VPN Client on the RV34x Series
Router Objective The Teleworker VPN Client feature minimizes the
configuration requirements at remote locations by allowing the device to
work as a Cisco VPN hardware client. When the T...