Anybody has experience that set the default outbound policy as block in access rules of rv220w? I configure my company router RV220W to block all outbound service traffic, just allow outbound service as : http, https, smtp, dns_tcp / udp. it works fine for some hours, the next day, the rules like expired, the https / smtp / DNS service fail to outgoing, only the http is still ok? What happen, any idea? Now I just set the default outbound policy as allow, all traffic can go out, but that is meaningless for a firewall device.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...