This router is a 10/100 router. Even with dual wans that is the max you will get. The mtu settings is an idea set that to manual 1500. The security on the router like SPI feature on the router is a security device that will slow down your router. This router is not designed for speed, it is designed for vpn and security. If you were to disable alot of the security features you could speed up the router a bit. Naturally the speed will be faster going through the modem cause it is not as strong a firewall.
The mtu settings are under the setup tab then select the network tab. Then go to the wan settings if you scroll down the page and the mtu settings are there for both wans. The maximum bandwidth the router can produce with both wans is 200 mbps. You might have to tweet the security features on the router to achieve the optimal speeds. You will be comprimising the security though.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...