Does anyone know of a phone tech service that can help me set up my Cisco WAP4410N pre-owned router?
I am not a tech personality and need a bit of hand holding in setting up my WAP4410N device. My old router Linksys 1500 seems to be having dropping signal issues and I purchased this WAP4410N online to replace it. I need to know if I made the right choice in the purchase and how to set it up.
I'm a Cisco Engineer and I'm sorry, I don't have a phone number to give you but I actually replied to this post to clarify something:
The WAP4410N is not a router, it is just an Access Point, so if you are trying to replace a router, this is really not the right device. As you can see this unit has a single port on the back as opposed to 4 LAN ports and 1 Internet port.
If you are correct o the model number then my advice is for you to look for another device, an actual router so that you can replace your Linksys unit.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...