Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Downloading New Config to SR 520

I previously posted about the inability to get a DHCP address from the LAN port of the SR 520.  I have set up another older laptop (I needed the serial port) and opened a session via the CLI.  The <show run> command yields a configuration file that looks nothing like the default config files from

https://www.myciscocommunity.com/docs/DOC-5167

I have tried <write erase> and then reload, but I end up with the same config file.

I am trying to TFTP using the pumpkin utility, but have not had luck placing the default configuration into the "startup-config" directory I created (it was not there).

Right now I am using the console port and the LAN ports do not service the DHCP requests.  Would I be able to copy the file over on the console port without having to set up the TFTP server?

Should I consider another route to get this resolved?

1 REPLY
New Member

Re: Downloading New Config to SR 520

I ended up using the console port to configure the startup script manually.  It took a while but worked fine.

Thanks for the link to the factory default file.

-Steve

1800
Views
0
Helpful
1
Replies