I don't know how or if it's possible to set up two SMTP servers, but I know that may ISPs block SMTP traffic that is not directed to one of their SMTP servers. You could try picking just one SMTP server, and find out if it can be conacted on a non-standard port. A lot of SMTP providers allow for this.
If you can configure a single SMTP server on a non-standard port, you should be able to conatct that SMTP server from anywhere on the internet because the traffic won't be blocked (at least not port-based blocking, which is what most ISPs use).
So in a scenario where WAN1 is the ISP who owns the SMTP server and WAN2 is a diferent ISP that blocks standard SMTP traffic...
1) If both WANs are working, SMTP traffic goes out WAN1. No problem.
2) If only WAN1 is working, SMTP traffic goes out WAN1. No problem.
3) If only WAN2 is working, SMTP traffic goes out WAN2, but is not blocked because it is on a non-standard port. No problem.
Hello, This article will describe how to configure PPTP VPN on the new
RV340/345 routers from the Small Business series. RV340/345
Configuration The first step is to enable the PPTP Server: Go to VPN ->
PPTP Server Change PPTP Server: from Off to On Selec...
Article ID:5748 Use TheGreenBow VPN Client to Connect with RV34x Series
Router Introduction A Virtual Private Network (VPN) connection allows
users to access, send, and receive data to and from a private network by
means of going through a public or share...
Article ID:5728 Configure a Teleworker VPN Client on the RV34x Series
Router Objective The Teleworker VPN Client feature minimizes the
configuration requirements at remote locations by allowing the device to
work as a Cisco VPN hardware client. When the T...