Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Easy VPN Ip Address and Mask Information Request

Hello,

I have an RV320.  When creating an Easy VPN tunnel I am given the option of to provide an ip address and mask for the split tunnel configuration.  The manual states that this is the VPN tunnel's interface. 

Can someone explain why this interface ends in a zero?  I configure the interface for 192.168.10.1 /24 and when I save, it converts it to a network id of 192.168.10.0 /24.

What do I do with this interface or range?  Do I configure firewall rules to allow it to a specified vlan?  It currently will not allow access to my domain, only the router's management ip address.

Thanks,

JN

Everyone's tags (3)
420
Views
0
Helpful
0
Replies
CreatePlease to create content