I am having trouble getting quickVPN to work from home where I am using a Netgear WGT624 wireless router connected to my dsl modem. I can use quickVPN and make connection when bypassing the router and using only the dsl modem wired to my pc.
here is the log.txt:
2014/07/22 20:48:54 [STATUS]Remote gateway was reached by https ... 2014/07/22 20:48:54 [STATUS]Provisioning... 2014/07/22 20:49:03 [STATUS]Success to connect. 2014/07/22 20:49:03 [STATUS]Tunnel is configured. Ping test is about to start. 2014/07/22 20:49:03 [STATUS]Verifying Network... 2014/07/22 20:49:09 [WARNING]Failed to ping remote VPN Router! 2014/07/22 20:49:12 [WARNING]Failed to ping remote VPN Router! 2014/07/22 20:49:15 [WARNING]Failed to ping remote VPN Router! 2014/07/22 20:49:18 [WARNING]Failed to ping remote VPN Router! 2014/07/22 20:49:21 [WARNING]Failed to ping remote VPN Router! 2014/07/22 20:49:33 [WARNING]Ping was blocked, which can be caused by an unexpected disconnect. 2014/07/22 20:49:41 [STATUS]Disconnecting... 2014/07/22 20:49:46 [STATUS]Success to disconnect.
in case you are using one and the same PC in both scenarios: 1. DSL modem----Netgear WGT624--- PC and 2. DSL modem ---- PC, and in the case 1 tunnel works, but in case 2 tunnel does not work, what I can think of is the Netgear router to stop ESP packets. In other words - not to support IPSec Passthrough, or at least is not enabled
Maybe you should check the router for such option first. My guess is that it should be in the Firewall part
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...