Forwarding port with two interfaces WAN to same port. CISCO 891
Hi guys, I have a problem with my CISCO 891 Router.
I configured Internet failover with IPSLA, track and route map, these work fine and I want to configure port forwarding but I don't know how, I need the port forwarding working on the primary ISP(giga0) and change it when the primary ISP down and secundary (fast8) up.
I wrote this command:
ip nat inside source static tcp 192.168.1.202 3074 interface giga1 3074 and ip nat inside source static tcp 192.168.1.202 3074 interface fa8 3074
When I write the last command, this delete the first (I think, because has the same port and the same IP inside or the interfaces are WAN).
How I can homologate these commands? or How can I do to configure port forwarding to work with two WAN interfaces (Internet failover)?
Article ID:5748 Use TheGreenBow VPN Client to Connect with RV34x Series
Router Introduction A Virtual Private Network (VPN) connection allows
users to access, send, and receive data to and from a private network by
means of going through a public or share...
Article ID:5728 Configure a Teleworker VPN Client on the RV34x Series
Router Objective The Teleworker VPN Client feature minimizes the
configuration requirements at remote locations by allowing the device to
work as a Cisco VPN hardware client. When the T...
Article ID:5708 Configure the LAN and DHCP Settings on the RV34x Series
Router Objective A Local Area Network (LAN) is a network limited to an
area such as a home or small business that is used to interconnect
devices. LAN settings can be configured to li...