Is there a GUI for the SR520 similar to the ESW and AP541 devices? When trying to setup firewall and nat rules on the SR520, CCA 2.2(4) doesn't seem to have much for capabilities and the CLI is too advanced for a small business. I've tried to go the the IP address via HTTP, but I don't see any indication of a GUI unless there is a tar file that I need to install in flash for this to show up. What do others use to manage the SR520? This is the 5port FE SR520.
Does anyone have one of these in production? I found one small screen shot that looked like this should have it's own GUI. Is there a special file needed in flash or something in IOS needed for the GUI to work? When a browse to the IP via HTTP or HTTPS, I just get a page can't be displayed error.
Hello, This article will describe how to configure PPTP VPN on the new
RV340/345 routers from the Small Business series. RV340/345
Configuration The first step is to enable the PPTP Server: Go to VPN ->
PPTP Server Change PPTP Server: from Off to On Selec...
Article ID:5748 Use TheGreenBow VPN Client to Connect with RV34x Series
Router Introduction A Virtual Private Network (VPN) connection allows
users to access, send, and receive data to and from a private network by
means of going through a public or share...
Article ID:5728 Configure a Teleworker VPN Client on the RV34x Series
Router Objective The Teleworker VPN Client feature minimizes the
configuration requirements at remote locations by allowing the device to
work as a Cisco VPN hardware client. When the T...