network, we have 5 static IP one was configured to the router, then we have a server windows 2003 that will do streaming video but I not able to use the others Static IP so I can put one to the server. Any suggestion on the set up...
LAN IP 192.168 WAN IP 209.172.xxxx provided by our ISP provider
WRVS4400N only supports one public IP address, which is the WAN IP of the router. If you need to support multiple public IP addresses, you would need products such as RV120W or RV042+WAP4410N, or SA520W.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...