Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

HI,I want to ask one question about SRP 521W

   I have one SRP 521W router, It is slow when I configure it,And the memory  utilized very high(94%),but the CPU is nice.

   I was upgraded the last release firmware,The memory utilization keep in 78%,But I am still feeling it slowly when I configured it,How can I fix or correct configure it,Can to reduce the memory utilization.    I have one SRP 521W router, It is slow when I configure it,And the memory  utilized very high(94%),but the CPU is nice.
   I was upgraded the last release firmware,The memory utilization keep in 78%,But I am still feeling it slowly when I configured it,How can I fix or correct configure it,Can to reduce the memory utilization.

1 ACCEPTED SOLUTION

Accepted Solutions
Bronze

HI,I want to ask one question about SRP 521W

Dear Shipeng,

Thank you for reaching Small Business Support Community.

Since the firmware upgrade did not fix the problem, you can try disabling some by default enabled services that you may not need; things like:

Administration > Remote Management > SNMP and Local TFTP.

Network Setup > UPnP

Administration > Log

Network Setup > Firewall > Firewall Filter

If no Internet Protocol Television (IPTV), Network Setup > IGMP

You may also check on the Internet Access Control entries to get rid of any not needed entries.  Please check these out and let me know if there is any further assistance I can help you with.

Kind regards,

Jeffrey Rodriguez S. .:|:.:|:.
Cisco Customer Support Engineer

*Please rate the Post so other will know when an answer has been found.

Jeffrey Rodriguez S. .:|:.:|:. Cisco Customer Support Engineer *Please rate the Post so other will know when an answer has been found.
2 REPLIES
Bronze

HI,I want to ask one question about SRP 521W

Dear Shipeng,

Thank you for reaching Small Business Support Community.

Since the firmware upgrade did not fix the problem, you can try disabling some by default enabled services that you may not need; things like:

Administration > Remote Management > SNMP and Local TFTP.

Network Setup > UPnP

Administration > Log

Network Setup > Firewall > Firewall Filter

If no Internet Protocol Television (IPTV), Network Setup > IGMP

You may also check on the Internet Access Control entries to get rid of any not needed entries.  Please check these out and let me know if there is any further assistance I can help you with.

Kind regards,

Jeffrey Rodriguez S. .:|:.:|:.
Cisco Customer Support Engineer

*Please rate the Post so other will know when an answer has been found.

Jeffrey Rodriguez S. .:|:.:|:. Cisco Customer Support Engineer *Please rate the Post so other will know when an answer has been found.
New Member

HI,I want to ask one question about SRP 521W

Thanks very much,I will try it,Actully,I was disable some voice feature,I don't need them now,The router is better then before.

353
Views
0
Helpful
2
Replies