How do I configure the RV350 to have public IP addresses on the LAN interface
I have a rv350 and I want to connect it to my campus network to end up with a subnet. I'm replacing an old 2100 cisco router. I have a /27 network on the lan side and the up stream router is configured to route trafic to my WAN interface. I do not see any way to do this. The router wants to be a NAT.
Hello, This article will describe how to configure PPTP VPN on the new
RV340/345 routers from the Small Business series. RV340/345
Configuration The first step is to enable the PPTP Server: Go to VPN ->
PPTP Server Change PPTP Server: from Off to On Selec...
Article ID:5748 Use TheGreenBow VPN Client to Connect with RV34x Series
Router Introduction A Virtual Private Network (VPN) connection allows
users to access, send, and receive data to and from a private network by
means of going through a public or share...
Article ID:5728 Configure a Teleworker VPN Client on the RV34x Series
Router Objective The Teleworker VPN Client feature minimizes the
configuration requirements at remote locations by allowing the device to
work as a Cisco VPN hardware client. When the T...