Hi Ryan, thank you for using our forum, my name is Luis I am part of the Small business Support community. I apologize for your inconvenience, in this case I could advice you to perform a factory reset before upgrade your device, then upgrade your device and after that perform a factory reset again, also please download the firmware again also make sure you are using the correct file, here you can download it 220.127.116.11.
Now, here is the last release 18.104.22.168, I advise you to use this version, you could give a try.
It is updated sucessfully to 22.214.171.124. Problem is, this version does not support QuickVPN accounts.
I want to go back to 10.0.0.30 since this older firmware does support QuickVPN.
How do i downgrade back to the older firmware? I tried loading the older firmware file into the update tool on the remote login. Once it does its process, it still shows 10.0.3.10 and no quickvpn setup.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...