10-01-2010 05:27 AM
I am hitting an interesting issue between my router and switch. When I do a show cdp nei det on my switch I see the public IP address of my router instead of the management IP address like I would expect. I can post parts of the configuration upon request.
Thanks,
Chris
Solved! Go to Solution.
10-01-2010 05:35 AM
CDP by default uses the first interface in the configuration, typically the one with lowest index count (Fa0/0, for example). You can change this with the following command (if you are using an IOS router):
UC500(config)#cdp source-interface ?
Async Async interface
Auto-Template Auto-Template interface
BVI Bridge-Group Virtual Interface
CDMA-Ix CDMA Ix interface
CTunnel CTunnel interface
Dialer Dialer interface
Dot11Radio Dot11 interface
FastEthernet FastEthernet IEEE 802.3
Integrated-Service-Engine cisco integrated service engine module
Lex Lex interface
Loopback Loopback interface
Multilink Multilink-group interface
Null Null interface
Tunnel Tunnel interface
Vif PGM Multicast Host interface
Virtual-Access Virtual Access interface
Virtual-Dot11Radio Virtual dot11 interface
Virtual-PPP Virtual PPP interface
Virtual-Template Virtual Template interface
Virtual-TokenRing Virtual TokenRing
Vlan Vlan IEEE 802.1q
vmi Virtual Multipoint Interface
10-01-2010 05:35 AM
CDP by default uses the first interface in the configuration, typically the one with lowest index count (Fa0/0, for example). You can change this with the following command (if you are using an IOS router):
UC500(config)#cdp source-interface ?
Async Async interface
Auto-Template Auto-Template interface
BVI Bridge-Group Virtual Interface
CDMA-Ix CDMA Ix interface
CTunnel CTunnel interface
Dialer Dialer interface
Dot11Radio Dot11 interface
FastEthernet FastEthernet IEEE 802.3
Integrated-Service-Engine cisco integrated service engine module
Lex Lex interface
Loopback Loopback interface
Multilink Multilink-group interface
Null Null interface
Tunnel Tunnel interface
Vif PGM Multicast Host interface
Virtual-Access Virtual Access interface
Virtual-Dot11Radio Virtual dot11 interface
Virtual-PPP Virtual PPP interface
Virtual-Template Virtual Template interface
Virtual-TokenRing Virtual TokenRing
Vlan Vlan IEEE 802.1q
vmi Virtual Multipoint Interface
10-01-2010 05:51 AM
That worked perfectly!
Thanks!
10-01-2010 06:22 AM
Thanks for the info. What if we are hitting the same issue between 2 switches? Instead of the management vlan showing up we are seeing other layer 3 vlans that would not be accessable.
Thanks,
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: