How to configure multiple HTTP port forwards to unique IP addr?
When i try to set two HTTP single port forwarding rules for distinct IP addresses inside my LAN, i get a message that the rules are identical when they're not. Below is the specific setup i'm trying to put in effect:
rule 1 - HTTP forward port 3001 to internal port 3001 to IP addr 192.168.0.300
rule 2 - HTTP forward port 3002 to internal port 3002 to IP addr 192.168.0.301
I can activate one of these rules, routing the traffic correctly, but when i try to activate both i get the error message. any help out there?
Hello, This article will describe how to configure PPTP VPN on the new
RV340/345 routers from the Small Business series. RV340/345
Configuration The first step is to enable the PPTP Server: Go to VPN ->
PPTP Server Change PPTP Server: from Off to On Selec...
Article ID:5748 Use TheGreenBow VPN Client to Connect with RV34x Series
Router Introduction A Virtual Private Network (VPN) connection allows
users to access, send, and receive data to and from a private network by
means of going through a public or share...
Article ID:5728 Configure a Teleworker VPN Client on the RV34x Series
Router Objective The Teleworker VPN Client feature minimizes the
configuration requirements at remote locations by allowing the device to
work as a Cisco VPN hardware client. When the T...