I recently upgraded my Charter internet from 30 mb to 60 mb. If I do a speedtest.net test directly connected to the modem, I get 60 mb+. If I am connected to my WRSV4400N router, I only get 25-27 mb, the same speed I used to get with the 30 mb connection.
Is there a configuration parameter to set to run at the speed of the modem?
yes, you "Fixed it" but by turning off IPS, you may need more work to maintain the same level of security, anything you "turn on" will slow the total throughput as the processing is increased, if it was necessary to disable this, it may require different hardware to accomplish this securely, there is another post on this issue, and near the end a sales manager talks about it. It looks like the ASA series with the AIP module installed is your best bet currently. here is the thread link
hope this all helps, I use a Cisco 2851XM as my edge router for my home network, and I can pull a 300+ down by 20+ up on a tunneled 6to4 network through the tunnel or not... although, I don't have an AIP module as of yet and the access to the speeds are due to a relatively recent upgrade to DOCSIS3 in the Austin area, I'm pretty sure the speeds they are a coming, and with the speed comes the possibility and likelihood of more attacks for us all... so, IPS is a good thing.
Hello, This article will describe how to configure PPTP VPN on the new
RV340/345 routers from the Small Business series. RV340/345
Configuration The first step is to enable the PPTP Server: Go to VPN ->
PPTP Server Change PPTP Server: from Off to On Selec...
Article ID:5748 Use TheGreenBow VPN Client to Connect with RV34x Series
Router Introduction A Virtual Private Network (VPN) connection allows
users to access, send, and receive data to and from a private network by
means of going through a public or share...
Article ID:5728 Configure a Teleworker VPN Client on the RV34x Series
Router Objective The Teleworker VPN Client feature minimizes the
configuration requirements at remote locations by allowing the device to
work as a Cisco VPN hardware client. When the T...