How to setup VoIP/Ipsec on SRP527W using web gateway
I'm trying to setup a IPSec tunnel and VoIP for the Cisco SRP527W-K9-G5 but all I find are examples using the cisco ios which this model doesn't support. I'm using the web interface to the router and there is no examples to follow.
There is no manual, the online help is not very helpful either.
I've tried going to the "Voice" tab but could not figure out where to put the SIP or the phone number.
And is there any examples, manual or anything that shows how to create a ipsec tunnel using the srp527w's web interface?
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...