I successfully set up 4 connections between the RV220W and 4 third party routers. Ping, etc. works fine.
However now I found out that the connection can only be established by the third party routers. When I try to initiate the connection either on the network where the RV220W sits or directly from the RV220W's admin interface, the connection won't be established. The settings on both ends regarding Initiator / Responder are set to "Both".
Hello, This article will describe how to configure PPTP VPN on the new
RV340/345 routers from the Small Business series. RV340/345
Configuration The first step is to enable the PPTP Server: Go to VPN ->
PPTP Server Change PPTP Server: from Off to On Selec...
Article ID:5748 Use TheGreenBow VPN Client to Connect with RV34x Series
Router Introduction A Virtual Private Network (VPN) connection allows
users to access, send, and receive data to and from a private network by
means of going through a public or share...
Article ID:5728 Configure a Teleworker VPN Client on the RV34x Series
Router Objective The Teleworker VPN Client feature minimizes the
configuration requirements at remote locations by allowing the device to
work as a Cisco VPN hardware client. When the T...