Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

IP addresses taken and not released (SPR527W)

Hello,

I have  the SRP527W model.

The situation is the devices are taking the IP address from the DHCP pool and I am running out.

The setting for the client lease time is 0 = 0 means one day

I could change it to 5 = 5 mins at start up

How do i change the settings so other devices that are not on the network anymore give back the Ip addresses to the pool and not keep them forever.  I am running out of IP address in the DHCP pool and have so far have a max of 120 users.

I would also like to note I ve not set any of these addresses as static to the client.  If they are not on the network after a week, the ip address should go back to the pool, whats going on?

Thanks

981
Views
0
Helpful
0
Replies
CreatePlease to create content