Is there anybody knows how the maximum bandwidth for an MPLS TS link is calculated? Litterature seems to indicate that it corresponds to interface bandwidth command but I do not think that this is the case.
pauillac#show ip ospf mpls traffic-eng link
OSPF Router with ID (18.104.22.168) (Process ID 100)
Area 0 has 2 MPLS TE links. Area instance is 6.
Links in hash bucket 8.
Link is associated with fragment 1. Link instance is 6
Link connected to Broadcast network
Link ID : 10.1.1.2
Interface Address : 10.1.1.1
Admin Metric te: 1 igp: 1
Maximum bandwidth : 12500000
Maximum reservable bandwidth : 64000
Number of Priority : 8
Priority 0 : 64000 Priority 1 : 64000
Priority 2 : 44250 Priority 3 : 44250
Priority 4 : 44250 Priority 5 : 44250
Priority 6 : 44250 Priority 7 : 44250
Affinity Bit : 0x0
The maximum bandwidth for a 100 Base T interface is 12500000 and 1250000 for a 10 Base T interface. In fact, it seems that the interface bandwidth is multiply by 125.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...