Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

IPSEC VPN - RV180 - Connected but no Route

I have just purchased an RV180 Small Business VPN router to connect to our office SRP527W CISCO.

I have configured the VPN and it says it is connected.  The office shows RX and TX traffic but the Remote (RV180) only shows TX traffic.

The office router shows a route in the routing table pointing to the new network:

192.168.20.0 255.255.255.0 202.94.xx.xx ipsec0

however the remote (RV180) does not have a reverse Route.

If I try to set up a static route I do not have the option of choosing ipsec (only WAN or LAN).

I have deleted and resetup the RV180 end multiple times and checked the settings on both ends to confirm that they are the same but still can not ping between the networks either way.

I've upgraded to the latest firmware but the result is the same.

Why wouldn't a configured and connected IPSEC VPN not show up in the routing table?

Rob

Everyone's tags (1)
3 REPLIES
New Member

Have you add VPN policy table

Have you add VPN policy table?

New Member

Yes I have, see attached

Yes I have, see attached

New Member

My VPN is work but no need to

My VPN is work but no need to add static route

 

273
Views
0
Helpful
3
Replies
CreatePlease login to create content