I'm have a RV016 router running 188.8.131.52-tm firmware. I have enable PPTP server and is able to connect to the internal network with windows xp PPTP client.
The problem is that now i need to limit the PPTP client to be able to access to certain PC and not the whole network. I had set some rule but it seem to have no success, the PPTP client is still able to access to any PC in the RV016 LAN. Even now the PPTP passthrough is set to disable but still fail to block.
LAN subnet of the RV016 is 10.66.66.0/24, PPTP range is 10.66.66.195-10.66.66.205. The attachment is the access rule which i had set.
Can anyone help me with this? Or the access rule does not apply on PPTP traffic?
If you said RV016 access rule/acl does not apply to pptp but from the link >> https://supportforums.cisco.com/message/3139210, this user is able to use the rules to block the pptp client to access to internet which RV016 pptp server as gateway?
Article ID:5748 Use TheGreenBow VPN Client to Connect with RV34x Series
Router Introduction A Virtual Private Network (VPN) connection allows
users to access, send, and receive data to and from a private network by
means of going through a public or share...
Article ID:5728 Configure a Teleworker VPN Client on the RV34x Series
Router Objective The Teleworker VPN Client feature minimizes the
configuration requirements at remote locations by allowing the device to
work as a Cisco VPN hardware client. When the T...
Article ID:5708 Configure the LAN and DHCP Settings on the RV34x Series
Router Objective A Local Area Network (LAN) is a network limited to an
area such as a home or small business that is used to interconnect
devices. LAN settings can be configured to li...