I bought a linksys rv042 router to balance my network with 2 lines. I have 2 cable lines of 50/3 Megabits, and I want to get "one" of 100/6 megabits. This router has 2 options backup and load balance, when i use the backup option I get almost 50/3 but when I use load balance I get 20/6 ...someone knows why i dont get 100/6 ...??????
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...